When it’s windy my cameras droop, I have the metal ball but can’t seem to get them tight enough (even using pliers) to not droop. Any suggestions? Thanks
Use a rubber washer from a roofing screw and place it inside the swivel where you tighten the camera to hold it’s position. Works perfectly and the rubber gives the extra friction you need!
Here are a few suggestions that might help:
- Check the Equipment: Make sure that the metal ball and the mounting hardware are in good condition and functioning properly. Sometimes, wear and tear or defects in the equipment can contribute to instability.
- Use Additional Support: Consider using additional support mechanisms such as stabilizing arms or brackets to provide extra stability to your cameras, especially in windy conditions.
- Adjust Mounting Position: Experiment with adjusting the mounting position of your cameras to see if a different angle or orientation can help reduce the impact of wind on the drooping problem.
- Upgrade Equipment: If your current setup still isn’t providing the stability you need, you might consider investing in higher-quality mounting hardware or a more robust camera support system designed specifically for windy conditions.
- Consult Experts: Reach out to professionals or enthusiasts in photography or videography forums or communities for advice and recommendations based on their experiences dealing with similar challenges.